2W Non-maintained emergency packs with 3 hours duration and 5 years warranty

Constant power output LED emergency power supply with wide output voltage range, featuring LifePO4 battery technology with 5-year warranty.

• Constant power output LED emergency power supply with wide output voltage range
• Input relay switching
• High safety, high performance, long life LifePO4 battery
• Integrated battery management system
• Standard and self-test emergency packs

Unit: mm

Basic wiring diagram

Fig A: With LED driver and LED module

Fig B: With LED module

Fig C: Loop in & out with LED module

• Before installation, set Pin short: Manual Test
• Connect the wire according to the wiring diagram
• L, N power on, Switch on S1. Then the load lamp turns on, the emergency driver indicator light turns green, emergency power supply is normal charging. Turn off Switch S1; the load lamp turns off
• Emergency Simulation: Switch on, the load lamp turns on, press the switch (TEST SWITCH), then switch to emergency mode, the indicator light of the emergency driver will be extinguished. Release the switch (TEST SWITCH), then the lamp is powered by LED driver, the indicator light will turn on

• Before installation, set Pin open: Automatic Test
• Connect the wire according to the wiring diagram. Remove the test switch on the LED Emergency Driver
• L, N power on, start the clock, and perform a periodic self-test. To replace the battery, turn off the power supply, and re-time

• The battery should be recharged and discharged semiannually in normal use conditions
• Do not connect to the circuit when the battery is not in use to prevent over-discharge of the battery due to self-consumption of the circuit board
• Please keep the battery away from the heat source when installing and using, and only be allowed to be used in a certain working temperature range
• The battery should be stored in a cool and dry environment
• After long-term storage, the battery is cycled every 6 months as required
• AC power is off, and the clock lasts for 7 days. Power on and re-time. To replace the battery, turn off the power supply, and re-time